Santrauka:
Baigiamajame darbe aprašyta gręžimo staklių valdymo sistema. Šią sistema sudaro
gręžimo variklis, kuris vykdo gręžimo darbą, bei žingsniniai varikliai pozicijos nustatymui. Staklių
judėjimas yra valdomas CNC valdikliu, prie kurio kompiuteris prisijungia per USB sąsają.
Kompiuteryje yra valdymo programos, kurias naudojant atliekami gręžimo darbai ruošinyje.
Ruošinių šablonai saugojami kompiuterio duomenų bazėje.
Baigiamąjį darbą sudaro:
• Įvadas, kuriame aprašoma darbo esmė ir nauda, sutiktos problemos bei laukiančios
užduotys.
• Analitinė dalis, kurioje aprašytos panašios gręžimo sistemos. Remiantis analizuojamomis
sistemomis buvo kuriama ši sistema.
• Projektinė dalis. Šioje dalyje pateikta sistemos struktūra, aptariama įranga, reikalinga
sistemai sukurti, vartotojo sąsajos modeliai bei reikalavimai sistemai.
• Praktinė dalis. Joje aprašoma kuriama sistema. Pateikiamos naudojamos programos,
valdiklių ir variklių jungimo schema bei parašytas programos kodas.
• Ekonominė dalis, kurioje surašyta naudojama įranga projekto kūrimui, apskaičiuota darbo
kaina bei projekto trukmė.
• Išvados, kuriose aprašyti darbo tikslų rezultatai.
Darbo apimtis.
Darbą sudaro 46 puslapių, 14 lentelių, 19 paveikslas, 7 literatūros šaltinių.
Description:
In the final work is described drill machine control system. This system is made of drill
engine, which controlling drilling operations and stepper motors for positioning. Machine
movement is controlled by CNC controller. CNC controller connected to computer by USB
connection. In computer where is programs which are used to control drilling operations in the
workpiece. Workpieces templates are stored in local database, inside computer system.
The final work consists of:
• An introduction describing the essence and benefits of the work and the problems
encountered.
• An analytical section describing similar drilling machine systems. Based on analyzed
drilling machine systems this paper was written.
• Project part. This section presents the structure of the system, discusses the equipment
required to create the system, user interface models and system requirements.
• Practical part. It describes the system being developed. Listed programs that were used to
write the thesis, wiring diagram of controllers and motors is shown and program code
written.
• The economic part, which lists the equipment used to create the project, the estimated cost
of the work and the duration of the project.
• Conclusions describing the results of the work objectives.
Scope of work. The work consists of 46 pages, 14 tables, 19 figures, 7 references.